How to Press a DTF Transfer Sheet

Please note that the following instructions are guidelines to follow, every heat press is different in terms of heat and pressure.  Use what works best for your heat press.  If you are unsure how to press, order our sample package so that you can try it out first.

DTF Transfer Sheets can be pressed on most garments including Light or Dark garments, 100% Cotton, Cotton/Poly Blend, 100% Polyester and hard substrates.

DTF Transfer Application Instructions

  • Preheat the garment for 10 seconds to remove excess moisture. Let the garment cool before adding the transfer.
  • Place the transfer on the shirt – white side down, image facing up. Place a Teflon or parchment paper over your image.
  • Press at 266-300°F for 7-10 seconds using firm pressure. (296 for 7°F seconds works best for us.)
  • Peel the transfer sheet away from the garment.  This is a Hot Peel, wait 5 seconds then peel.
  • Cover the image with another T-shirt, Teflon sheet or parchment paper and press again for 10-15 seconds.

Please note: If the image does not come off completely, repress with the image in place, then peel again. Press again and peel.

Care Instructions: Turn the garment inside out. Machine wash cold. No bleach. No softener. Do not dry clean or iron. Tumble dry low. 

 

How To Peel A UV-DTF Transfer Sheet

Ensure your application surface is clean, dry, and free of dust or oils for optimal adhesion. Use a lint-free cloth with alcohol to prep the surface if necessary.

Step 1: Prepare the label: Run a squeegee across the UV-DTF label prior to removing it from the carrier sheet. Peel the design away from the clear backing.

Step 2: Position the Label: Carefully position the UV-DTF label on the desired surface. Avoid touching the adhesive side to maintain its stickiness. Our adhesive is strong and permanent, so once its placed, it cannot be removed.

Once positioned, lightly press the label onto the surface to secure its placement without fully adhering it.

Step 3: Apply Pressure: Use a small, flat, and soft object (like a plastic card or a squeegee) to apply even pressure across the label.

Start from the center of the label and work your way outwards to eliminate any air bubbles and ensure a strong adhesion.

Step 4: Finalize the Application: After firmly rubbing the design onto the surface, carefully start peeling the label at a 45-degree angle. DO NOT allow the ends of the clear film to touch or else you will not be able to pull them apart.

Go over the label one more time with your flat object to secure any edges or corners.  If a portion is not adhering, repeat Step 4.

The successful application of our transfers is under your care and responsibility. We kindly remind you that we cannot be held accountable for any complications or damage that may occur during or after the application process.

Additionally, please be aware that the capacity of glasses can differ across various brands. It may be necessary for you to adjust based on the specific brand of glasses you are using.  Be sure to measure your application area prior to peeling the backing.